t ta tb tc td te tg th ti tk tl tm tn to tp tr ts tt tu tv tw tx ty tz

Перевод: tensile strength

[существительное]
предел прочности на разрыв

Тезаурус:

1. For a specimen of Muscovite of this shape Orowan found that the tensile strength was about 460,000 p.s.i., that is to say nearly twenty times as strong as a specimen in which the cracks did not have to cross the planes of weakness.
2. The result, says ICI, is a material that retains physical and dimensional stability at 1000C - twice the temperature needed to melt glass - and some tensile strength at 750C.
3. Except for the case of a pre-existing open fracture, the rock tensile strength To has to be overcome for a hydraulic fracture to be initiated.
4. Estimates of tensile strength, are based on relationships between tensile, compressive and shear strength parameters and the log-derived Young's Modulus and Bulk Modulus, contained in the MECHPRO computer program.
5. The tensile strength of spruce, for instance, is around 17,000 p.s.i.
6. Each of these hazards can reduce the tensile strength by several percent.
7. The compressive strength of most constructional materials exceeds their tensile strength; therefore, the failure of a strut is usually due to buckling or gyration.
8. Pottery and commercial tinplate may have roughly the same tensile strength but if a cup is dropped on the floor it will shatter, perhaps almost explosively.
9. Nor did its low tensile strength help either.
10. Griffith then took ordinary cold rods of the same glass about a millimetre thick and broke them in tension, finding that they had a tensile strength of about 25,000 p.s.i.
11. Light, high tensile strength fibres confer stiffness and strength to a polymer resin that binds them into a rigid three-dimensional form.
12. The actual tensile strength of ordinary glass and ceramics can be quite high; the reason why we do not make motor cars, for instance, from them is not that they are weak but that they are far too brittle.
13. From the above observations one can deduce that either the tensile strength is zero due to pre-fracturing, or that the tectonic component of was underestimated.