i ia ib ic id ie if ig ih ii ik il im in io ip iq ir is it iu iv iw ix

Перевод: impedance

[существительное]
импеданс [эл.] ; полное сопротивление

Тезаурус:

1. The output impedance is about 0.02 ohm at the 5V end and 0.1 ohm at the 15V end of the range.
2. Experimental work has been done on other human joints but there is nothing which tells us about, for example, the impedance of the wrist.
3. Plugging a Japanese Strat into the high impedance Input 1 socket, the Champ booted up in the Normal channel.
4. This provides a relatively high input impedance looking into their bases and a low output impedance at the emitters.
5. This chip is an octal tri-state non-inverting buffer type whose outputs are put into a high impedance state when either pin or pin is set high.
6. The output is loaded by a 10k resistor to avoid the following circuitry seeing a high impedance when the switch is open, thus becoming susceptible to interference or hum pickup.
7. All loudspeaker drive units have an impedance characteristic which varies with frequency, thus normally presenting the amplifier with a complex load whose characteristics are constantly varying according to the music signal.
8. TR1 (a field-effect device) provides a small amount of r.f. gain and its high input impedance is ideal for directly matching the input tuned circuit.
9. Both circuits attempt to tackle the problem of crossover distortion in a basically identical manner: they try to make the load impedance, RL, appear to be very much higher to the main amplifier than it really is.
10. Determine the mutual impedance between the coil and the solenoid of Example 4.1.
11. No significant differences were seen with the higher dose of collagen (5 g/ml), probably because the impedance aggregometer is more sensitive to smaller platelet aggregates than to the larger aggregates which would have been induced by the high-dose collagen (Ingerman-Wojenski et al, 1982).
12. The volume control VR1 also sets the input impedance of the amplifier at 47 kilohms (47k).
13. When this pin is held high, the output pins are set into a high impedance state, behaving as though they are, in effect, switched off.