m ma mb mc md me mf mg mh mi mk ml mm mn mo mp mr ms mt mu mv mw mx my mz

Перевод: machined

машинной обработки

Тезаурус:

1. The parts of the generator were cast in the brass and iron foundries and machined in the machine shop, the completed parts being delivered to the train-lighting department, where the armatures were wound and the generator completely assembled.
2. Shells were also machined from forgings produced elsewhere.
3. The first shell was completely machined on 18 August 1942.
4. The stand is a machined steel column with telescopic height adjustment, the top is threaded to accept the banjo assembly, and tool rest from the lathe.
5. These were brought to the works as square baulks or round logs, or alternatively, as scantlings, all being converted and machined in the sawmill and the pieces sent to the erecting shop for assembly.
6. The finished machined material was then transported from this section via the special wagons, to the underframe shop: one load for the wagon side, and one load for the carriage side, each morning, for the first shift, and a repeat delivery in the afternoon for the second shift.
7. tons) in the Works Iron Foundry and machined by the Machine Shop, the component parts also being manufactured in the Machine Shop and wired and fitted in the Electric Shop.
8. Mechanics pushed our aircraft into a hangar and machined us a new stud for our exhaust pipe.
9. The timber arrived in the finishing shop and was machined by the aid of jigs and stops, passing from machine to adjacent benches where it was fitted together.
10. If you have a 2.25 the cost of a new 2.5 head is not economically viable, so the alternative is to have the head machined to take the 2.5 inserts (ETC 6278) at 6.58 each plus VAT and probably 50 to 75 to have the head reconditioned at the same time.
11. How Harry Boot and I achieved our end is shown in the photograph of one of the original anode blocks machined in December 1939.
12. These loaded special wagons were then taken to the Underframe Machine Shop (formerly the Old Lifting Shop), which contained the following machinery: multispindle drills, beam-end milling machines, shears, saws, straightening machines, oxy-acetylene burners, punches, and an overhead crane, where the material was machined as necessary.
13. First, all the wood for the body was finished and machined in the Sawmill, and transported to the relevant positions for assembly, as follows: No 1 stage was the fitting of the floor, No 2 stage, the ends moving, to No 3 stage when the sides were temporarily fitted, after being job-built.