|
v
va
vb
ve
vf
vh
vi
vl
vm
vn
vo
vp
vr
vs
vt
vu
Перевод: valve
[прилагательное]
клапанный; ламповый;
[существительное]
пистон [тех.] ; клапан [тех.] ; вентиль [тех.] ; золотник [тех.] ; заслонка [тех.] ; электронная лампа ; вальва [бот.] ; створка [бот.]
Тезаурус:
- My personal view is that they will run on lead free if the valve gear and engine are in perfect condition before using unleaded petrol.
- Wide range of engines including the 90hp Turbo Diesel and the 160hp 16 valve petrol engine.
- Recent tests by Rover have shown that, on the four cylinder car engines not designed to run lead free, valve seat regression still occurs when using Carbonflo and lead free fuel.
- With ball-valves the best remedy is complete replacement of the old valve with an equilibrium type; this is designed so the valve cannot be forced open by the incoming water pressure, only by movement of the float arm.
- Should the valve clearances be adjusted hot or cold? 2.
- The only effective remedy is to install hardened valve seats or a replacement cylinder head, both expensive options.
- The military type oil cooler gives no problems in use Fit the whole system including oil temp gauge, multiblade fan and oil pressure relief valve The timing should not be altered for altitude variations
- When this complication does occur these days (and the only reports are from the United States) it may necessitate open-heart surgery for the replacement of the defective valve.
- However, many cars built within the last few years have hardened valve seats, or alloy cylinder heads that need little (simply a retune) or no modification to use unleaded petrol.
- With the older Portsmouth valve, adjust by carefully bending the ball arm.
- If the engine has exhaust valve seats of suitable material, as fitted in Rover V8 and 2.5 litre petrol engines, then this will not happen.
- It will cost more to repair the burnt valve seats and valves than the saving on fuel.
- Note that some types of motorised valve cannot be serviced and have to be replaced (a job that will entail draining down the entire system), but on many newer models it is possible to replace the valve motor and free the valve spindle if it is jammed, without having to interfere with the plumbing.
|
